From the k71 704 00 oil cap to the brakes, there are a dozen little things you need to know about your vehicle. Many components make up the engine and it’s important to have a little knowledge and understanding of certain things. For instance, the engine oil and filter are two vital parts of the vehicle and there may come a time when you have to get your hands dirty. So, isn’t it time you knew how to change your engine oil and filter?
Find a Safe Location to Work on the Vehicle
First of all, you must find a suitable place to park the vehicle. If you have a garage with a lot of space or a driveway, that would be ideal. It also means the area is typically safer than out on the street. Regardless, the vehicle must be in a safe place so that you aren’t compromised by other road users. Also, the vehicle must be secured on a level surface.
For instance, a parking lot would be ideal since the ground is flat. On the other hand, a grass verge isn’t. Grass isn’t technically stable as the vehicle can slip on it. So, your first step is to find somewhere safe to work and secure for the vehicle. And ensure the handbrake is applied too.
Chock the Wheels and Empty the Oil Flush
To secure the vehicle, use chocks and place them behind each wheel. This is really important as it ensures the vehicle cannot roll backward onto you. If you wanted to, you could use chocks on either side of the wheel to ensure it cannot move either way. Next, you can empty the engine oil flush and run the engine for a short while. Of course, before you move on to the next step, it’s crucial to let the motor cool. Make sure you don’t lose the k71 704 00 oil cap.
Use Jacks to Lift the Car and Drain the Oil
Once cool, lift the car using a jack and axle stand. You want the vehicle at a height that is comfortable for you to work underneath. Ensure you place sufficient axle stands around the vehicle, including the chassis support, to ensure it’s stable. Do not work on the vehicle or get underneath it unless the vehicle is secured by the stands.
Now, you want to locate the splash guard (if you have one) and remove it. Once you’ve done that, find the engine oil sump plug and place a pan or container underneath. Put on some safety gloves and remove the plug. The oil will begin to drain out into the container. While this happens, wash the plug and install a new washer (if necessary).
Remove the Oil Filter and Install a New One
Place a second container under the engine oil drain and remove the filter. The O ring must come away with the filter as you’ll need this later. Clean the filter housing and add a small amount of fresh engine oil to the filter and the O ring. Carefully install the new filter and when the oil has drained away, replace the sump plug. Refit the splash guards and lower the car back onto level ground.
Refill the Sump
Since the old oil has been drained, you’ll need to replace it with fresh oil. So, carefully fill the sump up with oil and secure it with an oil cap. Let the engine run for a minute or two and check the oil levels again just to make sure everything is fine.
A Simple Task
Anyone with a little know-how should be able to handle an engine oil and filter change. Of course, if you aren’t confident or just can’t handle the job, get a professional to help. It’s a task that can be accomplished within a relatively short period. Just make sure you replace the k71 704 00 oil cap so that you don’t have issues with running out of oil. …